Short Course on Homes – Covering The Basics

Decorate Your Home or Office with Crown Moulding

Crown moulding is defined as a decorative piece of wood, metal, or plaster that is used to accentuate some places in your home or office. This decorative material can be used either on the exterior or interior of your home or office. Mouldings are installed to frame the walls, ceilings, windows, and door openings of your home or offices.

The areas from your wall to ceiling will have nice effect with the use of this decorative trim called the crown moulding. The importance of a crown moulding is as significant as choosing a frame for an expensive painting. It is important to choose your crown moulding in relation to the design of your home to avoid negative attention. Be wary not to make the crown moulding too big or too small or too simple in comparison to the interior of the room so as not to cheapen the look of the room. Some homeowners would choose crown moulding to suit their personal style, and this shows the importance of this accent piece.

Crown moulding is generally installed along the seams where the wall meets the ceiling in a room.
Why People Think Services Are A Good Idea

Your home or office will have an increased value, glamour and beauty if you install crown moulding.
The Beginners Guide To Improvements (Getting Started 101)

There are some guidelines to follow before a crown moulding is installed.

The first preparation is by locating all the studs in your walls and ceiling joist. You can do this by making some light pencil marks at the point where you see the crown moulding up as you nail it.

Figuring out which way the ceiling joists are running is your next preparation. Figuring this out is important especially in a square room where you only have the nailers for the top of your moulding on two of the four walls.

The size of your triangle nailer can be found easily by using a framing square. You can still produce a good job even if the nailer does not fit perfectly.

The next advice is not to have the nailer forcing your moulding not to sit flush against the wall and ceiling by leaving a little room.

Your next guideline is the installation of the nailers on the walls without ceiling nailers. Position the nailer against the wall and ceiling, then pre-drill the nailer using a counter sink drill bit into the studs on the walls. Afterwards, use a 3 inches coarse thread drywall screw for attaching to the stud.

Another pointer is putting a reference line on the wall at the height you would want the moulding to sit on the wall. A way to do this is by taking a piece of scrap moulding and place it on the wall and ceiling in a proper way, then do a pencil mark on the wall at the bottom of the trim.